Studio 4 to 10

[Keith]

Same here, but went from 6 to 10

Keith

Keith at adnetltd.co.uk
Sent from my iPhone

> On 15 Jun 2020, at 13:32, Doug Easterbrook <doug at artsman.com> wrote:
> 
> hi ROb.
> 
> I agree with Mike.
> 
> From studio 5 unicode all the way to 10.1
> 
> and pay attention to your data files — the data within needs to be verified after conversion that  the formerly non-unicode data can be read by unicode.
> 
> we converted from non-unicode while using postgres and I know that it id far more particular about valid content than omnis was - and it caused us grief.     so if Mike says there is a full convert, have a look.
> 
> We also ran some tests that included reading all data both before and after converison to compare that it was the same or at least readable.
> 
> 
> 
> 
> Doug Easterbrook
> Arts Management Systems Ltd.
> mailto:doug at artsman.com
> http://www.artsman.com
> Phone (403) 650-1978
> 
>> On June 15, 2020, at 5:06 AM, Rob Mostyn <mostyn at platformis.net> wrote:
>> 
>> Hi All,
>> 
>> but a particular hi to Das.  You just mentioned a studio 4 to 10 conversion…  I have just been asked by an old client to do a similar exercise.  This is non unicode Studio 4 to 10.
>> 
>> What are the steps (with the benefit of hindsight) that you went through?
>> 
>> Was it as simple as
>> -    non unicode 4 to unicode 4 conversion
>> -    unicode 4 to 5 conversion
>> -    5 to 6 conversion
>> -    etc to 10
>> 
>> or was there interim testing done along the way that had to be done at various steps?
>> 
>> Thanks,
>> Rob
>> _____________________________________________________________
>> Manage your list subscriptions at http://lists.omnis-dev.com
>> Start a new message -> mailto:omnisdev-en at lists.omnis-dev.com
> 
> _____________________________________________________________
> Manage your list subscriptions at http://lists.omnis-dev.com
> Start a new message -> mailto:omnisdev-en at lists.omnis-dev.com