O7: Duplicated Sequence

Wendy wizardcompserv at gmail.com
Wed Apr 11 04:17:26 EDT 2018


On windows - all versions from 7 upwards - have you checked for write behind
cashing being on?

The setting can be found as follow:-
1) Control Panel -> System -> Hardware-> Devise Manager

2) Click on the ‘+’ beside the Disc Drives entry and right click on the
entry for the hard drive.

3) Select ‘Properties’

4) On the displayed screen select ‘Policies’

5) Towards the bottom of the screen there is a check box which reads ‘Enable
write cashing on the disk’  If there is a tick in the check box click on the
box so that it is unchecked.

6) Click OK

This can be reset by doing updates to the computer.

Kind regards
Wendy Osbaldestin
Wizard Computer Services
Tel:  01260271647
Mobile: 07740541021

-----Original Message-----
From: omnisdev-en [mailto:omnisdev-en-bounces at lists.omnis-dev.com] On Behalf
Of Daniel Sananes
Sent: 11 April 2018 09:02
To: OmnisDev List - English
Subject: O7: Duplicated Sequence

Hi all

We have problems with Omnis assigning the same sequence-number twice or
trice every now and then.
I export and import with omnis data transfer and then the sequencenumber are
correct again.

But the problems does not go away.
Is there something else I can do?

hälsning
Daniel Sananés
Kopparbergs Bryggeri AB
Tel:  + 46 (0)736 70 40 70

_____________________________________________________________
Manage your list subscriptions at http://lists.omnis-dev.com Start a new
message -> mailto:omnisdev-en at lists.omnis-dev.com 



More information about the omnisdev-en mailing list